s2n-tls before 1.7.6: TLS1.3 Content Type bypass MITM Silent Record Drop
CVE-2026-16317 Published on July 21, 2026

Silent Drop of TLS 1.3 Encrypted Records in s2n-tls
Missing validation of the outer content_type byte on TLS 1.3 encrypted records in s2n-tls allows an active man-in-the-middle to silently discard individual application data records without either endpoint detecting the modification. RFC 8446 Section 5.2 requires that the outer content_type of all encrypted TLS 1.3 records must be application_data (0x17). The s2n-tls AEAD implementation hardcodes this value in the additional authenticated data rather than using the actual wire byte, so the outer content_type is not covered by the authentication tag. This enables selective suppression of application data. In HTTP pipelining scenarios, dropping a TLS record containing an HTTP request can cause request/response desynchronization, where subsequent responses are delivered to the wrong requests. In write-heavy workloads, a dropped record containing a write request can result in undetectable data loss when the client interprets a subsequent success response as confirmation of the dropped write. All TLS 1.3 connections are affected. Both TLS clients and servers are affected. TLS 1.2 and QUIC connections are not affected. We recommend you upgrade s2n-tls to version v1.7.6

Vendor Advisory NVD

Vulnerability Analysis

CVE-2026-16317 can be exploited with network access, and does not require authorization privileges or user interaction. This vulnerability is consided to have a high level of attack complexity. The potential impact of an exploit of this vulnerability is considered to have no impact on confidentiality, a high impact on integrity, and a small impact on availability.

Attack Vector:
NETWORK
Attack Complexity:
HIGH
Privileges Required:
NONE
User Interaction:
NONE
Scope:
UNCHANGED
Confidentiality Impact:
NONE
Integrity Impact:
HIGH
Availability Impact:
LOW

Weakness Type

Improper Validation of Integrity Check Value

The software does not validate or incorrectly validates the integrity check values or "checksums" of a message. This may prevent it from detecting if the data has been modified or corrupted in transmission. Improper validation of checksums before use results in an unnecessary risk that can easily be mitigated. The protocol specification describes the algorithm used for calculating the checksum. It is then a simple matter of implementing the calculation and verifying that the calculated checksum and the received checksum match. Improper verification of the calculated checksum and the received checksum can lead to far greater consequences.


Products Associated with CVE-2026-16317

stack.watch emails you whenever new vulnerabilities are published in Amazon Aws or Aws S2n Tls. Just hit a watch button to start following.

Amazon Aws
 
Aws S2n Tls
 

Affected Versions

AWS s2n-tls: